- New PIN code authorization algorithm v2 for MY25+ cars
- Engine Control Module calibrations (Service → Engine → Calibrations)
- Brake Control Module calibrations (including hydraulics and sensors) (Service → Brakes → Calibrations)
- GEP3 (Volvo 3-cylinder) engine support: oil level, temperature, service reset, calibrations, and DIDs
- Offline configuration view for all cars assigned to the account
- Software signature check in the VBF loader interface
- Resolving VCM11 PIN from a binary dump
- Favorite configuration parameters selection
- Custom values for configuration parameters
- Full configuration parameters view (including unknown ones)
- Combining backup, IMMO data retrieval, and flashing into a single action
- DEM calibration reworked to support new cars
- SUM calibration now informs the user if remeasurements are needed
- ECU reset list in the Service tab now contains the complete list
- Flashing: major improvements and optimizations
- UI corrections when another car is connected to VTool
- Automatic PSMD reset after ingress/egress offset changes
- Minor optimizations and corrections
download for Windows 7